| |
 |
| |
Introduction:
Amerikool Heat Transfer was established through a joint venture agreement with C, G, & J INC. of the United States and G.D.M. Heat Transfer of the United Kingdom. Their primary purpose was to supply high-pressure aluminum air to oil coolers to the aftermarket at a quick turn around and at a fair price.
C, G, & J Inc. acquired sole ownership in 2000. With the same commitment to fast service and a quality unit, C, G, & J Inc has taken it to a new level. C, G, & J installed a new flux brazing furnace and is able to build custom air to oil coolers to the customers specifications at even better turn around time than before. Amerikool Heat Transfer can build high-pressure oil coolers that will withstand operating pressures up to 400 psi. With the manufacturing process, Amerikool can build the oil coolers from 1” to 8” thick.
Our Markets
Amerikool has considerable experience in Heat Transfer Design and Manufacturing Process. This enables us to offer cooling equipment for a very wide spread of markets ranging from automotive vehicles, through trucks and compressors up to large industrial applications. We also supply our units to other heat exchanger Companies. Our range includes but is not limited to the following industries:
- Trucks
- Agriculture
- Industrial
- Racing
- Compressor
- Military
- Hospital
- Plant
- Specialist Automotive
- Power Stations
- Grasscutting Machinery
- Marine
The Manufacturing Process:
Amerikool Heat Transfer uses a multi galleried extruded tube in a variety of sizes to meet the customer’s requirements. By using the multi galleried tubes, we are able to meet all the cooling requirements including areas of high ambient temperatures. A cladded aluminum fin is used to braze the fin to the tube, and then a 6mm header plate that is cladded on both sides is used for the header plate. All units are assembled and brazed in a controlled atmosphere furnace. By using a controlled atmosphere furnace (CAB) you can be assured of a 100% bond between the tube and the fin, which gives you a strong unit. You are also able to do specialty units of one at a time. Amerikool Heat Transfer is committed to building the highest quality oil cooler at a fair price with the least amount of lead-time. We specialize in one unit at a time.
Technical Data:
Tube:
We use a specially made multi galleried tube that was specifically made for G.D.M. to meet the wide range of cooling and thickness requirements.
Fin:
The fin material is .006 in thickness with 10% cladding on both sides to give an even and strong bond between the tube and fin.
Header Plate:
The header plate ranges between a 1/8 to 1/4 depending on the pressure requirements of the oil cooler. The material is double sided and is 3003/4343.
All Aluminum Air to Oil Cooler
Differential Cooler Core
Micro-Extruded Tube Design vs. Bar & Plate Design
|
|
|
